Eneo DMR-104 Instrucciones de operaciones descargar pdf (Pagina 28)

User’s Manual

If you want to erase recorded data on the selected device,

highlight Clear and press the

button. You will be asked

whether or not you want to delete the data.

If you want to use a USB hard disk drive, highlight Use and

press the

button after connecting the device. Highlight

Don’t Use and press the

button if you want to stop using

the device.

CAUTION: Do NOT disconnect the USB cable or the power from the device while copying video clips.

If the USB cable is disconnected while copying video clips, archived data might be lost.

Highlight the boxes beside Mirror and press the

button. The DVR can be set up to mirror Source disks to designated

Dest. (destination) disks selected from internal hard disk drives. Refer to the Chapter 4 – Disk Mirroring for further

information on setting up disk mirroring.

Monitoring

Highlight Monitoring and press the

button, and the Monitoring setup screen appears.

Figure 12 : System – Monitoring setup screen.

The DVR can be configured to run self-diagnostics and report the results.

Highlight the Settings box beside the desired event (System, Check Recording, Check Alarm-In, Disk Almost Full,

Disk Bad, or Disk Temperature), and press the

button.

Highlight the Settings box beside System and press the button. You can select the interval that you want the DVR

to run self-diagnostics on the system. You can select from 1 hr. to 30 days or Never.

Highlight the Settings box beside Check Recording and press the button. The Check Recording screen appears.

Highlighting Schedule On and pressing the

button toggles On and

Off. When set to On, you can select the day, time range and interval

that you want the DVR to run self-diagnostics on the recorder. The

Interval can be selectable from 1 min. to 7 days or Never. Highlight

the + and press the

button to add a schedule item. The

box allows

you to delete a check recording schedule.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Sin comentarios

Eneo DMR-104 Instrucciones de operaciones Pagina 28