Eneo DMR-104 Instrucciones de operaciones descargar pdf (Pagina 36)

User’s Manual

Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.

Highlight the Port Number Setup… box and press the button. The Port Number Setup screen appears.

NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,

Callback, Watch, Search and Audio) from your network administrator.

Change the numbers by highlighting them and using the Up and Down

arrow buttons to increase or decrease the number. The factory default

Port settings are:

Remote Admin: 8200

Remote Callback: 8201

Remote Watch: 8016

Remote Search: 10019

Remote Audio: 8116

NOTE: The system restarts automatically after changing the port settings.

Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected

with the PC running RAS or WebGuard.

CAUTION: When changing the port settings, you must change the port settings on the PC running

RAS as well. Refer to the RAS manual for details.

Selecting DHCP from the Type and highlighting Save button reads the current IP address of the DVR configured by

DHCP (Dynamic Host Configuration Protocol) network.

Selecting ADSL (with PPPoE) allows you to set up the ADSL network.

Highlight the box beside ID and press the button. A virtual keyboard appears allowing you to enter the ID for ADSL

connection.

Highlight the box beside Password and press the button. A virtual keyboard appears allowing you to enter the

password for ADSL connection.

NOTE: Entering the ID and Password and highlighting OK reads the current IP address of the DVR configured

by the ADSL network.

If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever

the unit is turned on.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Sin comentarios

Eneo DMR-104 Instrucciones de operaciones Pagina 36