Eneo GLC-1601 Instrucciones de operaciones descargar pdf (Pagina 98)

APPENDIX 3

The ARP Function

Setting the IP Address

The Ethernet interface on the LANCam has a default IP address (192.168.1.168) that most likely needs to be changed

to make it work on your local network. You need to acquire a unique IP address (ask your network administrator). For

the initial setting of the IP address the LANCam needs to be connected to the same network segment as your client,

and the IP address can then be conﬁgured by using a combination of ARP and ping command.

Use any of the following ways to set the IP address within thirty seconds after booting the LANCam (re-cycle the

power). Setting IP using the method below can only be done on the Ethernet interface.

ARP and ping from Windows or MS-DOS

The user can open the PC’s MS-DOS windows from the WINDOWS 98 operation system, or open the PC’s Command

Prompt windows from either the WINDOWS 2000 or the WINDOWS XP operation system.

• Start a DOS prompt window

• Type the following in 30 seconds after the booting: arp -s <IP address> <Ethernet address>

[or arp -s <IP address> < MAC address>]

ping <IP address>

Example:

arp -s 192.168.1.100 00-0C-0C-00-00-01

ping 192.168.1.100

The IP address now is: 192.168.1.100.

ARP and ping from UNIX or GNU/Linux

• Start a shell

• Type the following as superuser (root): arp -s <IP address> <Ethernet address>

[or arp -s <IP address> < MAC address>]

ping <IP address>

Example:

arp -s 192.168.1.100 00-0C-0C-00-00-01

ping 192.168.1.100

The device responds to the ping in the examples above if the new address was conﬁgured. Note, this method will set

the IP address permanently.

NOTE: The default account and password after the reset are „admin” and „9999”.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 104

Sin comentarios

Eneo GLC-1601 Instrucciones de operaciones Pagina 98