Eneo KBD-2 Especificaciones descargar pdf (Pagina 35)

6.4 DVR5 protocol for the DVR for the version 3.1.0 and over Installation of the DVR5 protocol when one DVR is used.

NOTE: When you set the protocol to DVR5, the keyboard operates as the DVR’s keyboard only you must install domes to the DVR only.

RS-232

When you control the PTZ camera by the DVR, follow as below.

1. Connect RS-232 cable between RS-232 Port of DVR and DVR port of the J-box. (This connection enables DVR control remotely from KBD controller)

2. Connect RS-485 cables between the DVR and PTZ cameras.

3. Connect the power jack to the power port of the keyboard.

A. Input password (Factory setting is

9 9 9 9)

B. Open the menu of the KBD controller by pressing

CTRL + MENU key.

C. Set as below in Network menu.

NOTE: The baud rate of DVR/AUX should be the same as one of the RS-232 of the DVR

4. How to setup DVR:

D. Switch the DVR on.

E. Enter the Menu according to the DVR’s instruction manual.

F. Change the Port to „RS-232” of the remote control in the devices menu.

G. Conﬁrm matching the setup of RS-232 with the keyboard.

Ex: Baud Rate: 9600, Data Bit: 8, Stop Bit: 1, Parity: None)

H. Change the Remote Control to „Remote Control2” in the devices menu.

I. Change the Port to „RS-485” in the PTZ menu of the camera of the devices menu.

J. Conﬁrm matching the setup of RS-485 of the PTZ menu with PTZ cameras.

K. Set the PTZ menu according to PTZ cameras.

NOTE: The baud rate of all PTZ cameras should be used one speed type (ex. All 9600 or all 2400)

NOTE: The product of FASTRAX should be used „FASTRAX2”

L. Set the ID number according to PTZ cameras.

M. Set the system ID number to 1.

Set Baud Rate

1. DOME1: 9600

2. DOME2: 9600

3. RS-232: 9600

Com Ports

1. DOME1: NONE

2 DOME2: NONE

3. RS-232: DVR5

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Sin comentarios

Eneo KBD-2 Especificaciones Pagina 35