Eneo KBD-2 Especificaciones descargar pdf (Pagina 37)

6.4.2 Installation of DVR5 protocol when many DVR is use

When you control PTZ cameras on many DVRs, you need RS-232 to RS-485 converter.

PTZ cameras are connected to RS-232 to RS-485 converter by the RS-232 port of the DVR and the keyboard is connected through the RS-485 port of the DVR.

Follow as below.

1. Connect RS-485 cable between RS-485 Port of DVR and the DOME1 port of the keyboard.

2. Connect RS-232 cable between RS-232 Port of DVR and the RS-232 Port of the RS-232 to RS-485 converter.

3. Connect PTZ cameras to the RS-485 Port of the RS-232 to RS-485 converter.

4. Repeat the step 1-3 each DVR.

5. Set the system ID number of each DVR from 1 to the last DVR increasing 1.

6. Set the network menu of the keyboard as below.

NOTE: The baud rate of DOME1 should be the same as one of the RS-485 of the DVR

7. How to setup DVR:

A. Switch the DVR on.

B. Enter the Menu according to the DVR’s instruction manual.

C. Change the Port to „RS-485” of the remote control in the devices menu.

D. Conﬁrm matching the setup of RS-485 with the keyboard.

Ex: Baud Rate: 9600, Data Bit: 8, Stop Bit: 1, Parity: None

E. Change the Remote Control to „Remote Control2” in the devices menu.

F Change the Port to „RS-232” in the PTZ menu of the camera of the devices menu.

G. Conﬁrm matching the setup of RS-232 of the PTZ menu with PTZ cameras.

H. Set the PTZ menu according to PTZ cameras (PRODUCT and ID).

NOTE: The baud rate of all PTZ cameras should be used one speed type (ex. All 9600 or all 2400)

Set Baud Rate

1. DOME1: 9600

2. DOME2: 9600

3. RS-232: 9600

Com Ports

1. DOME1: DVR5

2 DOME2: NONE

3. RS-232: NONE

RS-232 to RS-485 converter

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios

Eneo KBD-2 Especificaciones Pagina 37

Comentarios a estos manuales