Eneo DLR3-08N/160CD Especificaciones descargar pdf (Pagina 28)

BAUD RATE

DOME 1 : 9600

DOME 2/DVR : 9600

MUX/KBD : 9600

DVR/AUX : 9600

ALARM/AUX : 9600

SAVE AND EXIT

PORT DEFINITIONS

DOME 1 : DOME

DOME 2/DVR : AUX IN

MUX/KBD : NONE

DVR/AUX : DVR1 (or DVR2)

ALARM/AUX : NONE

SAVE AND EXIT

2.11 Install with Standalone DVR Series

Figure 9: DVR Connection diagram

DVR1 or DVR2 can be set by following method though the menu system and screen are different.

If user wants to connect with DVR, proceed as the following order:

1. Connect RS-232 cable between RS-232 Port of DVR and DVR port of the J-box. (This connection enables DVR control remotely from KBD controller)

2. Connect 8 pin Multi cable between the data2 port of the KBD and the J-BOX.

3. Connect wires between the TX (+/-) of DVR and DOME2 (+/-) of J-Box. (This connection enables DVR PTZ control from the keyboard controller)

4. How to setup the KBD controller.

A. Switch the KBD controller ON

B. Input password (Factory setting is

9999)

C. Open the menu of the KBD controller by pressing

CTRL + MENU Key.

D. Set as below in Network menu.

PTZ control from DVR

DVR JUNCTION BOX

TX+ DOME 2 +

TX– DOME 2 –

DOME JUNCTION BOX

R(T)X+ DOME 1 +

R(T)X– DOME 1 –

Wire Connection

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sin comentarios

Eneo DLR3-08N/160CD Especificaciones Pagina 28