Eneo DLR3-08N/160CD Especificaciones descargar pdf (Pagina 7)

NO. SETTING DESCRIPTION

DOME1 Port Termination

Off

Mux/Slave Termination

Off

DOME2 Port Termination

Off

4~6 – (Reserved)

On Slave

Off Master

On PAL

Off NTSC

2.5 Dip Switch Setting

Termination and Master/Slave: Set the switches according to your conﬁguration.

Figure 4: DIP switches setting

2.6 Quick Installation Procedure

The dome camera must be installed by qualiﬁed service personnel in accordance with all local and federal electrical and building codes.

1. Fasten the J-box to a rigid wall using the supplied screws.

2. Connect the control signal wires between the dome and J-Box.

3. Connect the 12VDC power to the J-box.

4. Connect the supplied shielded 8 pin cable between the data1 port of the KBD and the data1 port of J-box. When you connect the dome camera to the

data2 port of J-Box, you should connect unshielded 8 pin cable between the data2 port of the KBD and the data2 port of J-box.

5. Connect the BNC cable from the Aux of appropriate switching device to J-box if needed.

6. Turn on the KBD power after all dome cameras have initialized.

7. The keyboard controller will search for all the attached dome cameras and then show the ID of dome cameras found.

8. The user will be prompted for a password for authorization. The user must enter a 4-digit PIN code. There are two authorization levels: operation only

and programming. The factory default passwords are 1111 for user, 9999 for administrator.

9. Move the joystick to control the camera direction (Pan, Tilt), and rotate the handle to the counterclockwise/ clockwise for zoom Out/In.

Depending on the amount of rotation or deﬂection of the joystick, zoom and pan/tilt speed will be change.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comentarios a estos manuales

Sin comentarios

Eneo DLR3-08N/160CD Especificaciones Pagina 7

Comentarios a estos manuales