Eneo DLR3-08N/160CD Especificaciones descargar pdf (Pagina 32)

3.2.2 Triplex Setup

Press key double of the multiplexer to enter the Main Menu. Enter the Unit Setup using and SET key of the multiplexer.

Network Type

RS 485

Baud Rate

9600 bps

Unit address

001 ~ 128

Protocol

• Selecting camera

(No. + CAM and PREV or NEXT)

With these selections, the keyboard controller has full control of the selected camera if it is a dome camera.

Viewing Full Screen (Multiplexer video input

No. + MAIN) The selected multiplexer’s video input will appear in the full-screen mode. Even if no camera is

connected to the multiplexer input, the screen will show the camera input (refer to the following example).

• Selecting multiplexer

(Mux ID No. + MUX)

Example: If the unit address of the Multiplexer is 128, you should press

1 2 8 + MUX to control the 128th Multiplexer.

If the spot output of the ﬁrst multiplexer is connected to the 16th video input of the second multiplexer, you can see selected camera output through the

spot output of the second multiplexer by pressing camera No. (1 to 31) + CAM

For example:

1+CAM will switch camera 1 to the second multiplexer spot output and you can control all functions of the selected camera using the

keyboard controller.

If you install more than two Multiplexers, the unit number (address) of the Multiplexer and selection of the Multiplexer must be the same in order to control

the Multiplexer with the Keyboard.

• In case no multiplexer conﬁguration

Picture on Spot Output of the Multiplexer (Mux’s video input 1 ~ 1 6 + AUX1~4)

Pressing Mux’s video input

1 ~ 1 6 + AUX1 ~ AUX4 will switch the selected video input number to the speciﬁc spot monitor output of the multiplexer.

The selected camera can be a dome camera or a standard camera. The Keyboard controller maintains control of the previously selected dome camera.

It does not change the main output of the multiplexer.

Example: 1 + MUX, 2 + AUX1 will switch camera 2 on multiplexer 1 to the spot output of multiplexer 1.

2 + MUX, 3 + AUX1 will show camera 3 on spot output of multiplexer 2.

1 + CAM will switch camera 1 to the spot output of multiplexer 1 and the keyboard controller has control of the selected camera.

• In case 2~5 multiplexer conﬁguration

In a 2~5 multiplexer conﬁguration, 1 8 + CAM will switch camera 18 (second camera on Multiplexer 2) to the spot output of multiplexer 2 and the

keyboard controller has control of the selected camera.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Comentarios a estos manuales

Sin comentarios

Eneo DLR3-08N/160CD Especificaciones Pagina 32

Comentarios a estos manuales