Eneo DLR3-08N/160CD Especificaciones descargar pdf (Pagina 44)

APPENDIX 2

Control the DVR for the Version 3.1.0 and over (available Version 3.0 and over of the keyboard)

Installation of the DVR4 protocol when one DVR is used

NOTE: When you set the protocol to DVR4, the keyboard operates as the DVR’s keyboard only.

DVR Connection Diagram

When you control the PTZ camera by the DVR, follow as below.

1. Connect RS-232 cable between RS-232 Port of DVR and DVR port of the J-box. (This connection enables DVR control remotely from KBD controller)

2. Connect 8 pin Multi cable between the data1 port of the KBD and the J-BOX.

3. Connect 8 pin Multi cable between the data2 port of the KBD and the J-BOX.

4. Connect wires between the TX(+/-) of DVR and RX(+/-) of PTZ cameras.

5. Switch the KBD controller ON

A. Input password (Factory setting is

9 9 9 9 )

B. Open the menu of the KBD controller by pressing

CTRL + MENU Key.

C. Set as below in Network menu.

BAUD RATE

DOME1 : 9600

DOME2/DVR : 9600

MUX/KBD : 9600

DVR/AUX : 9600

ALARM/AUX : 9600

SAVE AND EXIT

PORT DEFINITIONS

DOME1 : NONE

DOME2/DVR : NONE

MUX/KBD : NONE

DVR/AUX : DVR4

ALARM/AUX : NONE

SAVE AND EXIT

NOTE: The baud rate of DVR/AUX should be the same as one of the RS-232 of the DVR.

The port of DVR/AUX should be DVR4.

1 2 ... 39 40 41 42 43 44 45 46 47 48

Sin comentarios

Eneo DLR3-08N/160CD Especificaciones Pagina 44